Filter
Top Products
.
.
24
Follow this procedure to set up the printer for data transfer via the IrDA interface
1.
The printer IrDA interface is on the left side of the printer, below the
parallel interface connector.
2.
Locate the IrDA interface on the computer. Arrange the printer so the
IrDA interface ports are facing one another.
The IrDA interface ports must face one another and be approximately level, within a range of 15 degrees
left or right, 15 degrees up or down and not more than 1 metre (3 ft.) apart.
The following conditions may reduce the reception range of the IrDA interface.
If another IrDA device is attached.
If another infra-red device, like a set of wireless headphones or a remote controller, for example, is
broadcasting in the same area.
If the IrDA port is exposed to sunlight, fluorescent light, or any other strong light source like a
large torch.
If the IrDA port is not clean. Clean it with a soft, dry cloth if the port is smudged or dirty.
24