Filter
Top Products
84
Problem See Page
Other Printing Problems
Strange characters
Print job halts before completion
Characters on the screen do not match printed characters
Printing beyond edge of page
IrDA printing stops and paper is ejected
Printer prints incorrect number of lines on a page
Computer indicates a device time-out
Printouts are incomplete (only 50% to 75% of the page) or printed with large white
bands
94
95
96
96
96
96
97
97
Errors indicated by the CHARGE/ERROR lamp
CHARGE/ERROR lamp lights and stays on and buzzer beeps once.
The printer could not feed the paper or special media correctly from the feed slot on the front of the
printer or from the optional sheet feeder. Hold the printer steady with one hand then pull the sheet
from the printer slowly. Load the sheet straight into the printer, and press the
RESUME
button to
clear the error condition.
CHARGE/ERROR lamp lights and stays on and buzzer beeps twice.
The printer could not eject the paper correctly because the paper is over 58 cm long (23 in.). Remove
the paper. Break the print job into shorter pages. The printer cannot feed and eject paper longer than
58 cm (23 in.).
CHARGE/ERROR lamp lights and stays on and buzzer beeps three times.
No BJ Cartridge is installed on the printer. Install a BJ Cartridge. (p28)
CHARGE/ERROR lamp lights and stays on and buzzer beeps six times.
The battery pack is not installed correctly in the printer. Press the
POWER
button to switch the
printer off and install the battery pack. (pl9) Press the
POWER
button to switch the printer on again.
If the problem persists, replace the battery pack. (p62) To avoid problems with the battery pack,
always use the printer within the correct temperature range of 0°C to 35°C (32°F to 95°F).
84