Canon DR-G1130 Scanner User Manual


 
3-4
Chapter 3 Basic Operation
3. Confirm your settings.
[ON2]: When the [Match original size] or [Scanner’s
Maximum] page size setting is selected, scanning
document page lengths up to 3,000 mm (118.1") is
enabled.
[ON1]: When the [Match original size] or [Scanner’s
Maximum] page size setting is selected, scanning
document page lengths up to 1,000 mm (39.4") is
enabled.
[OFF]: When the [Match original size] page size setting is
selected, scanning document page lengths up to 432 mm
(17.0") is enabled.
4. Press [Enter].
The current setting is indicated by blinking square brackets
[ ].
5. Press the [ ] or [ ] key and press [Enter] to accept
the selection.
6. Press the Stop key to exit the User Mode.
IMPORTANT
Processing may be slowed when scanning in the Long
Document Mode.
When Long Document Mode is set to [ON1] (1,000 mm), a
scanned image may be lost if the scanning mode is set to color
and the image quality is set to [Image quality priority]. In the
event, scan the document in black and white or reduce the
image quality.
When Long Document Mode is set to [ON2] (3,000 mm), a
scanned image may be lost if the scan is performed at 400/
600 dpi or with the scanning mode set to color and the
scanning side set to [Duplex]. In the event, scan the document
at a lower resolution, in black and white, or with the scanning
side set to [Simplex].
When scanning using Long Document Mode, [High-Quality
Moire Reduction], [Auto orientation compensation], or
document orientation of [+90 degrees] or [-90 degrees] cannot
be used.
If a sheet is loaded at a skewed angle when scanning long
documents, it may be damaged by contacting both sides of the
transport path. So be careful to avoid loading documents at
skewed angles.
Paper jam detection may react slowly when scanning long
documents, which could result in jammed documents being
damaged. Be especially careful to avoid paper jams.
To feed each document page manually when scanning long
documents, press the [Separation Off] key on the control
panel.
Enter Key
Separation
Off Key