Filter
Top Products
4-6
Chapter 4 Other Functions
3. User Mode Functions
The following functions are available in the User Mode.
■ Separation Mode Setting
If double feeding or a paper jam occurs, change to
Separation Mode.
HI: Use if friction between sheets is great, and you are
feeding documents that are difficult to separate.
Normal: Use this setting normally.
LO: Use when feeding fine documents.
IMPORTANT
On [HI], as the separation power is great, the paper may tear. If
this happens, use [Normal] or [LO].
■ Buzzer (Beeper) Control Setting
The beeper (“buzzer”) sounds when you press the control
panel keys and when a scanning error occurs.
ON2: The beeper sounds when a scanning error occurs,
and when a control panel key is pressed.
ON1: The beeper sounds when a scanning error occurs.
OFF: The beeper never sounds.
■ Double-Feed Control Setting
Select whether double feed detection is enabled when in
Count-Only mode. If set to [ON], double feeds are
detected during feeding in Count-Only mode.
There are two methods of double feed detection,
comparing the length of documents and detecting
unevenness between documents by ultrasonic sensors,
which can be set according to the ISIS/TWAIN driver.
(See p. 8-5)
In Count-Only mode, double feed is set to be detected by
ultrasonic sensors.
■ Staple Detection Setting
Select whether staple detection is enabled when the Count-
Only mode is enabled.
ON: Detects staples in the Count-Only mode.
OFF: Does not detect staples in the Count-Only mode.
Staple detection during scanning is set with the ISIS/
TWAIN driver. (See p. 8-5)
■ Staple Detection Level Setting
Sets the staple detection sensitivity level.
[1] is the default setting, [2] provides higher sensitivity,
and [0] provides lower sensitivity.