Filter
Top Products
8-4
❚ Cannot receive a document manually.
You may have disconnected the call by pressing Start or dialling the remote receiving ID after hanging up the handset.
• Always press Start or dial the remote receiving ID before hanging up the handset. Otherwise you will disconnect the call.
• When your telephone line uses rotary pulse, switch to tone dialling on your telephone before dialling 25 (the remote receiving
ID).
Energy Saver Mode may have been set.
• Disable Energy Saver Mode. (→ Reference Guide)
❚ Print quality is poor.
You may not be using the correct type of paper.
• Make sure you load paper that meets the paper requirements for the machine. (→ Reference Guide)
The sending fax machine may not be functioning properly.
• The sending fax machine usually determines the fax’s quality. Call the sender and have them make sure the top cover and
scanning glass of their fax machine are clean.
Error Correction Mode (ECM) may be disabled.
• Make sure ECM is on. (→ p. 9-6)
❚ Faxes do not print.
The cartridge may not be installed properly.
• Make sure the cartridge is installed properly. (→ Reference Guide)
The cartridge may need to be replaced.
• Determine if the problem is with the cartridge, and replace if necessary. (→ Reference Guide)
❚ Faxed images are blotched or uneven.
The telephone lines may be in poor condition, or you may have a bad connection.
• Error Correction Mode (ECM) sending/receiving should eliminate such problems. However, if the telephone lines are in poor
condition, you may have to try again.
The sending fax machine may not be functioning properly.
• The sending fax machine usually determines the fax’s quality. Call the sender and have them make sure the top cover and
scanning glass of their fax machine are clean.
❚ Cannot receive using Error Correction Mode (ECM).
The other party’s fax machine may not support ECM.
• If the other party’s fax machine does not support ECM, then the document is received in normal mode without error checking.
ECM may be disabled.
• Make sure ECM is on. (→ p. 9-6)
❚ Errors occur frequently while receiving.
The telephone lines may be in poor condition, or you may have a bad connection.
• Lower the reception speed. (→ p. 9-4)
The sending fax machine may not be functioning properly.
• Call the sender and have them check that their fax machine is functioning properly.
08_EN.fm Page 4 Tuesday, February 19, 2002 8:37 AM