Filter
Top Products
E-20
2. Move the cursor to the start block from which
you want to change the text effect and then
press SET to register your selection.
3. Move the cursor to the end block up to which you want to change the text
effect and then press SET to register your selection and change the effect.
• At this point, the label printer returns to the text input screen.
To change the text effect for lines of text
1. After performing the two steps under “To assign text effects”, use u and i
to highlight “LINE” and then press SET.
2. Move the cursor to the start line from which you want to change the text
effect and then press SET to register your selection.
3. Move the cursor to the end line up to which you want to change the text
effect and then press SET to register your selection and change the text
effect.
• At this point, the label printer returns to the text input screen.
To change the text effect for specific characters
1. After performing the two steps under “To assign text effects”, use u and i
to highlight “CHARACTER” and then press SET.
2. Move the cursor to the start character from which you want to change the
text effect and then press SET to register your selection.
3. Move the cursor to the end character up to which you want to change the
text effect and then press SET to register your selection and change the text
effect.
• At this point, the label printer returns to the text input screen.
To change the text effect for a range of text
1. After performing the two steps under “To assign text effects”, use u and i
to highlight “TEXT” and then press SET.
2. Move the cursor to the start character from which you want to change the
text effect and then press SET to register your selection.
3. Move the cursor to the end character up to which you want to change the
text effect and then press SET to register your selection and change the text
effect.
• At this point, the label printer returns to the text input screen.
Important!
• Any of the following settings for the TEXT range or CHARACTER range can
cause vertical BOX lines between characters to overlap with characters.
STYLE: Italic (italic, italic + bold, italic + outline,
italic + shadow, italic + raised)
EFFECT: BOX
Certain FONT settings can also cause BOX lines to overlap with characters,
even when italic is not being used.
If you experience such overlapping, use BLOCK
range or LINE range to change the BOX
setting, or increase the PITCH setting on the
BLOCK FORMAT menu (see page E-25).