Filter
Top Products
Chapter 1 Unpacking and Installing the CSS
Installing a CSS 11800 Module
1-18
Cisco 11000 Series Content Services Switch Hardware Installation Guide
78-15146-02
5. For the procedure on installing a module into the CSS 11800 chassis, see the
“Installing a Module” section.
Installing a Module
You must power down the CSS 11800 chassis to install a module.
Note For the procedure on installing a passive SCM or SFM, see the “Installing a
Passive SCM or SFM” section. For information on removing and replacing a
module, see the “Removing or Installing a Module” section.
To install a module:
1. Properly ground yourself prior to handling the module. For example, wear the
anti-static wrist strap (included in the accessory kit) and stick the copper-tape
end of the strap to an unpainted metal surface on the chassis. Make sure that
the wrist strap makes good contact with your skin.
2. Locate an open slot in the chassis for the module. See Table 1-1 to identify
possible slots for the module. If necessary, remove a blank panel from the
chassis to expose a slot for the module.