Filter
Top Products
1-21
Cisco 11000 Series Content Services Switch Hardware Installation Guide
78-15146-02
Chapter 1 Unpacking and Installing the CSS
Installing a CSS 11800 Module
5. Insert the module into the board guides at the top and bottom of the slot and
slide it into the chassis by pressing firmly at the top and bottom of the
faceplate.
6. Close both ejectors simultaneously to seat the module connector into the
backplane.
7. Using a Phillips screwdriver, tighten the spring-loaded screws on the front of
the module faceplate.
• A SCM module begins diagnostics and initializes automatically.
• To power on the SFM or SFM2, reboot the CSS.
8. Power up the CSS.
9. To copy the boot configuration from the active SCM to the passive SCM, use
the passive sync command in boot configuration mode.
Passive Module Switchover
If the active SCM fails:
1. The CSS reboots and connections are terminated.
2. The CSS restores all configurations using the startup-config file.
3. The passive SCM becomes active automatically.
If an active SFM or SFM2 fails:
1. The CSS performs a cold boot and connections are terminated.
2. The CSS restores all configurations using the startup-config file.
3. A passive SFM becomes active automatically.
Note When the CSS 11800 chassis contains two passive SFMs or SFM2s and an active
switchover occurs, both passive SFMs or SFM2s switchover to become active
SFMs.