Filter
Top Products
1-19
Cisco 11000 Series Content Services Switch Hardware Installation Guide
78-15146-02
Chapter 1 Unpacking and Installing the CSS
Installing a CSS 11800 Module
3. Insert the module into the board guides at the top and bottom of the slot and
slide it into the chassis by pressing firmly at the top and bottom of the
faceplate as shown in Figure 1-8.
Figure 1-8 Installing a Module into a CSS 11800 Chassis
4. Close both ejectors simultaneously to seat the module connector into the
backplane.
5. Using a Phillips screwdriver, tighten the spring-loaded screws on the front of
the module faceplate. Once you install the module, it begins diagnostics and
initializes automatically.
If you installed a SFM or SFM2, you must reboot the chassis to activate it.
6. If you are installing additional GBICs in a Gigabit Ethernet module, position
the GBIC with its receive connector above its transmit connector.
49573