Filter
Top Products
Chapter 2 Cabling the CSS
Connecting Power Cords
2-30
Cisco 11000 Series Content Services Switch Hardware Installation Guide
78-15146-02
Connecting a CSS 11800 AC Power Cord
To connect an AC power cord to a CSS 11800:
1. Ensure that the CSS power switch is in the 0 (off) position.
2. Attach the power cord to the CSS by plugging the AC power cord connector
into the power receptacle at the front of the chassis as shown in Figure 2-19.
Figure 2-19 Connecting a CSS 11800 AC Power Cord
3. Plug the power cord into a dedicated 3-wire grounding receptacle.
4. Switch on the power on the CSS.
Connecting a CSS 11800 DC Power Cord
Before you install a DC power cord, see Appendix A, Specifications for DC
power supply safety warnings.
Warning
The DC power supply cord requires 12 AWG wire. The CSS 11800 draws a
maximum of 25 amps.
PS2 AC
power cord
PS2PS1
PS1 AC
power cord
PS1 power switch
PS2 power switch
49592