Filter
Top Products
1-8
Cisco Aironet 1400 Series Wireless Bridge Hardware Installation Guide. OL-4072-03
OL-4072-04
Chapter 1 Overview
Bridge Specifications
Bridge Specifications
The bridge, power injector, and power module specifications are listed in Table 1-1.
Table 1-1 Bridge, Power Injector, and Power Module Specifications
Category Bridge Power Injector and Power Module
Size Integrated antenna configuration:
11.4 in. W x 11.4 in. H 4.2 in. D
29.0 cm W x 29.0 cm H 10.7 cm D
External antenna configuration:
11.6 in. W x 11.6 in. H x 3.6 in. D
29.5 cm W x 29.5 cm H x 9.1 cm D
Power injector:
6.3 in. W x 6.4 in. H x 1.3 in. D
16.0 cm W x 16.3 cm H x 3.3 cm D
Power module:
6.2 in. W x 3.2 in. H x 1.7 in. D
15.7 cm W x 8.1 cm H x 4.3 cm D
LEDs Four LEDs on the back panel: Installation and
Alignment Mode, Ethernet traffic, bridge status, and
radio traffic
Three LEDs on the front panel: Uplink
activity, injector status, Ethernet activity
One LED on the side panel: Power
Connectors Bottom panel (left to right): Power injector dual-coax
ports (two F-type connectors), RSSI port (female
BNC connector)
Front Panel (external antenna configuration):
antenna Type N connector
Side panel (left to right): 48-VDC power
connector, two coaxial uplink F-type
connectors, and Ethernet RJ-45 connector
for 100BASE-T Ethernet
Operating Temperature –22 to 131
o
F (–30 to 55
o
C) 32 to 122
o
F (0 to 50
o
C)
Cold Start Temperature –22
o
F (–30
o
C) —
Warm-up time
(for full performance)
15 minutes after cold start —
Non-Operational
Temperature
–40 to 185
o
F (–40 to 85
o
C) –40 to 158
o
F (–40 to 70
o
C)
Humidity 0 to 100% (condensing) 0 to 90% (non-condensing)
Operational Vibration 0.001 G
2
/Hz from 5-100 Hz 0.001 G
2
/Hz from 5-100 Hz
Non-Operational
Vibration
0.01 G
2
/Hz from 5-100 Hz 0.01 G
2
/Hz from 5-100 Hz
Environmental Testing
Compliance
Integrated antenna configuration:
The enclosure has been successfully tested for
protection against the ingress of particulate
matter and fluids in compliance with a NEMA
Type 4 (IP56) enclosure rating.
External antenna configuration:
The enclosure has been successfully tested and is
in compliance with a NEMA Type 4 (IP56)
enclosure rating.
—