Filter
Top Products
2-10
Catalyst 3750-E and Catalyst 3560-E Switch Hardware Installation Guide
OL-9774-03
Chapter 2 Switch Installation
Installing the Switch
Installing the Switch
This section describes these installation procedures:
• Rack-Mounting, page 2-10
• Wall-Mounting, page 2-15
• Table- or Shelf-Mounting, page 2-18
• After Installing the Switch, page 2-18
The illustrations shown in this section show the Catalyst 3750E-48 PoE switch as an example. Except
for wall-mounting, you can install the Catalyst
3750-E and Catalyst 3560-E switches following the same
procedures.
Rack-Mounting
To install the switch in a 19-inch rack, follow the instructions described in this section.
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
precautions to ensure that the system remains stable. The following guidelines are provided to
ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest
component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in
the rack.
Statement 1006