Cisco Systems 3560-E Switch User Manual


 
2-18
Catalyst 3750-E and Catalyst 3560-E Switch Hardware Installation Guide
OL-9774-03
Chapter 2 Switch Installation
Installing the Switch
Table- or Shelf-Mounting
To install the switch on a table or shelf, locate the adhesive strip with the rubber feet in the mounting-kit
envelope. Attach the four rubber feet to the recessed areas on the bottom of the chassis.
Remove two Phillips truss-head screws from the switch side panels and use those screws to attach the
brackets to the switch (
Figure 2-16). Secure the brackets to the table or shelf with the appropriate
hardware.
Caution Do not use the 19-inch brackets to wall-mount the switch. The brackets are not suitable for
wall-mounting.
Figure 2-16 Attaching the 19-inch Brackets for Table- or Shelf-Mounting
158118
AC OK PS OK
100-240 V
10-5 A
50-60 H
Z
2
1
1 User-supplied screws 2 Phillips truss-head screws
When you complete the switch installation, see the “After Installing the Switch” section on page 2-18
for more information switch configuration.
After Installing the Switch
After the switch is installed, you might need to:
Configure the switch by running Express Setup to enter the initial switch configuration. For
instructions, see the switch getting started guide that shipped with the switch and also on Cisco.com.
Use the CLI setup program to enter the initial switch configuration. See Appendix C, “Configuring
the Switch with the CLI-Based Setup Program.”
Connect to the front-panel ports. See the “Installing Devices in the 10-Gigabit Ethernet Slots”
section on page 2-20 and the “Connecting Devices to the Ethernet Ports” section on page 2-26.