Filter
Top Products
3-13
Installing and Configuring Cisco Access Registrar, 4.2
OL-17221-02
Chapter 3 Upgrading Cisco Access Registrar Software
Upgrading Cisco Access Registrar Linux Software
# to perform the update. The script is located in:
#
# /opt/CSCOar/temp/10062.manual-changes
#
# Review the script to make sure it does not conflict with
# any of your VSA changes. Make sure you modify the script,
# if necessary, before you attempt to run it.
#
# To run the update script, type:
#
# aregcmd -sf /opt/CSCOar/temp/10062.manual-changes
#
##############################################################
Step 11 Review the script and make sure that the changes it will make do not conflict with any changes you
might have made to the VSAs. Modify the script if necessary.
Step 12 Record the location of the upgrade messages for future reference.
##############################################################
#
# These upgrade messages are saved in:
#
# /opt/CSCOar/temp/10062.upgrade-log
#
##############################################################
Upgrading Cisco Access Registrar Linux Software
This section describes the software installation process when upgrading to CAR 4.2 software on a Linux
workstation. This section includes the following subsections:
• Using uninstall-ar to Remove Linux Software, page 3-13
• Deciding Where to Install, page 3-14
• Installing Cisco Access Registrar Software from CD-ROM, page 3-14
• Common Linux Installation Steps, page 3-15
Using uninstall-ar to Remove Linux Software
The Linux version of Cisco AR software includes the uninstall-ar program in /opt/CSCOar/bin that
you use to remove Cisco AR software on Linux machines.
Note If you currently use the 3.5.2 Linux version, the uninstall-ar program removes /opt/CSCOar/data.
Before you run the uninstall-ar program, copy the /opt/CSCOar/data directory to a temporary location
such as /tmp. After you install the upgrade software, move the data directory back to
/opt/CSCOar/data.
Step 1 Log in to the Cisco AR workstation as a root user.
Step 2 To remove the Linux version of Cisco AR software, change directory to /opt/CSCOar/bin and stop the
server.