Filter
Top Products
3-19
Installing and Configuring Cisco Access Registrar, 4.2
OL-17221-02
Chapter 3 Upgrading Cisco Access Registrar Software
Configuring SNMP
Step 11 Record the location of the upgrade messages for future reference.
##############################################################
#
# These upgrade messages are saved in:
#
# /opt/CSCOar/temp/10062.upgrade-log
#
##############################################################
Configuring SNMP
If you choose not to use the SNMP features of CAR, the installation process is completed. To use SNMP
features, complete the configuration procedure described in
Configuring SNMP.
Configuring SNMP
If you choose not to use the SNMP features of CAR, the installation process is completed. To use SNMP
features, complete the configuration procedure described in
Configuring SNMP, page 4-14.
If you have modified the snmpd.conf file in the /cisco-ar/ucd-snmp/share/snmp directory, you must
back up this file before doing the upgrade process. The pkgrm removes the snmpd.conf file, even if it
has been modified.
After installing CAR 4.2 software with pkgadd, you must copy the snmpd.conf file back to the
/cisco-ar/ucd-snmp/share/snmp
directory. Restart the Cisco AR server using the following command:
/etc/init.d/arserver restart
Restarting Replication
Before you enable replication, you must first upgrade all replication slave servers to the same version of
Access Registrar software as the master server. Do not enable replication on the master server until all
slave servers have been upgraded.
Use the same process you used to upgrade the master server to upgrade any slave servers. If you retained
your configuration on the master, retain the configuration on the slaves, too.
After the same version of Cisco AR software has been installed on all slave servers, you can enable
replication on the master server again. After enabling replication on the master server, you can enable
replication on each of the slave servers.