Filter
Top Products
5-4
Installing and Configuring Cisco Access Registrar, 4.2
OL-17221-02
Chapter 5 Customizing Your Configuration
Configuring Multiple UserLists
Step 6 Use the set command to set the user’s group membership to the name of that group. The following
example sets
beth’s group membership to the Default group.
set Group Default
Step 7 Use the save command to save your changes:
save
Step 8 Use the reload command to reload the server:
reload
Note To be able to save your changes and reload the server after following this example, you
must have an actual script. Cisco AR displays a warning message when it detects missing
configuration objects.
Configuring Multiple UserLists
The basic site contains a single userlist, Default, and uses group membership to determine the type of
Service to provide each user. When all users are in the same UserList, each username must be unique.
You can, however, group your user community by department or location, and use separate UserLists to
distinguish amongst them. In this case, the users names must be unique only within each UserList. Thus,
you can allow a user
Jane in the North UserList as well as one in the South UserList.
When you have more than one UserList, you must have an incoming script that Cisco AR can run in
response to requests. The script chooses the authentication and/or authorization Service, and the Service
specifies the actual UserList (
Figure 5-1).
Figure 5-1 Using a Script to Choose a UserList
Table 5-3 provides an overview of the process. The following sections describe the process in more
detail.
Request
Choose
service
Scripts
Services
North-users
South-users
East-users
West-users
UserLists
North
West
East
South
22034