Filter
Top Products
12-14
Cisco ASA Series Firewall ASDM Configuration Guide
Chapter 12 Configuring Inspection for Voice and Video Protocols
MGCP Inspection
• RestartInProgress
The first four commands are sent by the call agent to the gateway. The Notify command is sent by the
gateway to the call agent. The gateway may also send a DeleteConnection. The registration of the MGCP
gateway with the call agent is achieved by the RestartInProgress command. The AuditEndpoint and the
AuditConnection commands are sent by the call agent to the gateway.
All commands are composed of a Command header, optionally followed by a session description. All
responses are composed of a Response header, optionally followed by a session description.
• The port on which the gateway receives commands from the call agent. Gateways usually listen to
UDP port 2427.
• The port on which the call agent receives commands from the gateway. Call agents usually listen to
UDP port 2727.
Note MGCP inspection does not support the use of different IP addresses for MGCP signaling and RTP data.
A common and recommended practice is to send RTP data from a resilient IP address, such as a loopback
or virtual IP address; however, the ASA requires the RTP data to come from the same address as MGCP
signalling.
Select MGCP Map
Add/Edit Service Policy Rule Wizard > Rule Actions > Protocol Inspection Tab >
Select MGCP Map
The Select MGCP Map dialog box lets you select or create a new MGCP map. An MGCP map lets you
change the configuration values used for MGCP application inspection. The Select MGCP Map table
provides a list of previously configured maps that you can select for application inspection.
Fields
• Use the default MGCP inspection map—Specifies to use the default MGCP map.
• Select an MGCP map for fine control over inspection—Lets you select a defined application
inspection map or add a new one.
• Add—Opens the Add Policy Map dialog box for the inspection.
MGCP Inspect Map
Configuration > Global Objects > Inspect Maps > MGCP
The MGCP pane lets you view previously configured MGCP application inspection maps. An MGCP
map lets you change the default configuration values used for MGCP application inspection. You can
use an MGCP map to manage connections between VoIP devices and MGCP call agents.
Fields
• MGCP Inspect Maps—Table that lists the defined MGCP inspect maps.
• Add—Configures a new MGCP inspect map.
• Edit—Edits the selected MGCP entry in the MGCP Inspect Maps table.
• Delete—Deletes the inspect map selected in the MGCP Inspect Maps table.