Filter
Top Products
31-16
Cisco ASA Series Firewall ASDM Configuration Guide
Chapter 31 Configuring the ASA IPS Module
Configuring the ASA IPS module
Step 3 Enter the IP address, username and password that you set in the “Configuring Basic IPS Module Network
Settings” section on page 31-12, as well as the port. The default IP address and port is 192.168.1.2:443.
The default username and password is cisco and cisco.
If the password to access IDM is lost, you can reset the password using ASDM. See the “Resetting the
Password” section on page 31-23, for more information.
Step 4 To save the login information on your local PC, check the Save IPS login information on local host
check box.
Step 5 Click Continue.
The Startup Wizard pane appears.
Step 6 Click Launch Startup Wizard. Complete the screens as prompted. For more information, see the IDM
online help.
(ASA 5510 and higher) If you configure virtual sensors, you identify one of the sensors as the default.
If the ASA series does not specify a virtual sensor name in its configuration, the default sensor is used.