Filter
Top Products
32-17
Cisco ASA Series Firewall ASDM Configuration Guide
Chapter 32 Configuring the ASA CSC Module
CSC SSM Setup Wizard
CSC Setup Wizard Management Access Configuration
To display the subnet and host settings that you have entered to grant access to the CSC SSM, perform
the following steps:
Step 1 Choose Configuration > Trend Micro Content Security > CSC Setup > Management Access
Configuration.
The management access configuration settings that you have entered for the CSC SSM appear, including
the following:
• The IP address for networks and hosts that are allowed to connect to the CSC SSM.
• The network mask for networks and hosts that are allowed to connect to the CSC SSM that you have
selected from the drop-down list.
Step 2 To add the IP address of the networks and hosts that you want to allow to connect to the CSC SSM, click
Add.
Step 3 To remove the IP address of a network or host whose ability to connect to the CSC SSM you no longer
want, click Delete.
The Selected Hosts/Networks table lists the IP addresses of networks and hosts whose connection to the
CSC SSM you have added.
What to Do Next
See the “CSC Setup Wizard Password Configuration” section on page 32-17.
CSC Setup Wizard Password Configuration
To change the password required for management access to the CSC SSM, perform the following steps:
Step 1 Choose Configuration > Trend Micro Content Security > CSC Setup > Password.
Step 2 In the Old Password field, enter the current password for management access to the CSC SSM.
Step 3 In the New Password field, enter the new password for management access to the CSC SSM.
Step 4 In the Confirm New Password field, reenter the new password for management access to the CSC SSM.
What to Do Next
See the “CSC Setup Wizard Traffic Selection for CSC Scan” section on page 32-17.
CSC Setup Wizard Traffic Selection for CSC Scan
To display the settings that you have made to select traffic for CSC scanning, perform the following
steps:
Step 1 Choose Configuration > Trend Micro Content Security > CSC Setup > Traffic Selection for CSC
Scan.