Filter
Top Products
4-10
Cisco ASA Series Firewall ASDM Configuration Guide
Chapter 4 Configuring Network Object NAT (ASA 8.3 and Later)
Configuring Network Object NAT
Step 4 Check the Add Automatic Translation Rules check box.
Step 5 From the Type drop-down list, choose Dynamic PAT (Hide).
Note To configure dynamic PAT using a PAT pool instead of a single address, see the “Configuring
Dynamic NAT or Dynamic PAT Using a PAT Pool” section on page 4-4.
Step 6 Specify a single mapped address. In the Translated Addr. field, specify the mapped IP address by doing
one of the following:
• Type a host IP address.
• Type an interface name or click the browse button, and choose an interface from the Browse
Translated Addr dialog box.
If you specify an interface name, then you enable interface PAT, where the specified interface IP
address is used as the mapped address. To use the IPv6 interface address, you must also check the
Use IPv6 for interface PAT checkbox. With interface PAT, the NAT rule only applies to the
specified mapped interface. (If you do not use interface PAT, then the rule applies to all interfaces
by default.) See Step 7 to optionally also configure the real interface to be a specific interface instead
of --Any--.