Filter
Top Products
30-18
Cisco ASA Series Firewall ASDM Configuration Guide
Chapter 30 Configuring the ASA CX Module
Configuring the ASA CX Module
• Launch PRSM from ASDM by choosing Home > ASA CX Status, and clicking the Connect to the
ASA CX application link.
What to Do Next
• (Optional) Configure the authentication proxy port. See the “(Optional) Configuring the
Authentication Proxy Port” section on page 30-18.
• Redirect traffic to the ASA CX module. See the “Redirecting Traffic to the ASA CX Module”
section on page 30-19.
(Optional) Configuring the Authentication Proxy Port
The default authentication port is 885. To change the authentication proxy port, perform the following
steps. For more information about the authentication proxy, see the “Information About Authentication
Proxy” section on page 30-5.
Note (Single mode) You can also set the port as part of the ASDM startup wizard. See the “(ASA 5585-X)
Changing the ASA CX Management IP Address” section on page 30-14.
Guidelines
In multiple context mode, perform this procedure within each security context.
Detailed Steps
Step 1 In ASDM, choose Configuration > Firewall > Advanced > ASA CX Auth Proxy.