Filter
Top Products
3-6
Cisco Broadband Access Center for Cable Installation Guide 2.7
OL-19105-01
Chapter 3 Installing Components
Installing Components Using the Graphical User Interface
<NR_HOME>/usrbin/nrcmd -N admin -P changeme "dhcp reload"
Caution Be aware that you also must configure client-classes, scope selection tags, policies, and scopes before
you can use the Network Registrar server. See the Network Registrar User’s Guide for information about
configuring these entities.
Validating Extensions
In the nrcmd program, run the following command and verify the output is the same:
nrcmd> extension list
100 Ok
dexdropras:
entry = dexdropras
file = libdexextension.so
init-args =
init-entry =
lang = Dex
preClientLookup:
entry = bprClientLookup
file = libbprextensions.so
init-args = BACC_HOME=/opt/CSCObpr,BACC_DATA=/var/CSCObpr
init-entry = bprInit
lang = Dex
prePacketEncode:
entry = bprExecuteExtension
file = libbprextensions.so
init-args =
init-entry =
lang = Dex
Note The <BACC_HOME> and <BACC_DATA> values may be different in your installation.
Also in the nrcmd program, run the following command and verify the output is the same:
nrcmd> dhcp listextensions
100 Ok
post-packet-decode: dexdropras
pre-packet-encode: prePacketEncode
pre-client-lookup: preClientLookup
post-client-lookup:
post-send-packet:
pre-dns-add-forward:
check-lease-acceptable: