Filter
Top Products
36
Flash Disks and Flash Memory Cards in the GRP
78-4339-09
Implementing Additional Configuration and Maintenance Tasks
Figure 14 Installing and Removing Flash Memory Card or Flash Disk
Both slots can be used at the same time. Use the following procedure to install a Flash memory card or
Flash disk:
Step 1 Facing the GRP front panel, hold the Flash memory card or Flash disk with the connector end of the
card toward the slot and the label facing right. (See Figure 14a.)
Note The Flash memory card or Flash disk is keyed and cannot be seated the wrong way. The
ejector button will not pop out if the card is not properly inserted.
Step 2 Insert the card into the appropriate slot until the card completely seats in the connector at the back of
the slot, and the ejector button pops out toward you. (See Figure 14b.)
SLOT-0
SLOT-1
RESET
AUX
EJECT
SLOT-0
SLOT-1
RESET
AUX
EJECT
a
H10703
b
c
SLOT-0
SLOT-1
RESET
AUX
EJECT