Filter
Top Products
6-17
Cisco Provisioning Center User’s Guide
78-11339-01
Chapter 6 Configuring the Cisco NI-1 DLSAM Equipment Module
Working with Service Element Profiles
Cisco 6100/6130
Modem Card
Type
The modem card type (line card
type) that contains this physical
port
CAPADSL,
DMT2ADSL,
2B1QSDSL
CAPADSL
Modem Card
Subtype
The modem card subtype. This
attribute provides support for
FLEX cards. If a FLEX card is
present, it will be set to 4xFLEX
and if a FLEX card is not present,
it will be set to Other. This attribute
is uploaded and cannot be changed.
4xFLEX, Other *
DSL Port Type Specify the physical port type. ModemPort, Line
Port
ModemPort
Connection
Time-out
This is the provisioned connection
timeout (according to timer type
specified). This parameter can only
be modified when the subscriber
object is locked.
1-240 1
ATU-C DMT-2
Bit Swapping Enabling this attribute allows the
modem to that the subscriber is
connected to utilize bit swapping
(if capable). This will allow it to
acknowledge bit swap requests
from the far end and to request bit
swapping when necessary.
Enabled, Disabled Disabled
Trellis Code Enabling this attribute allows
trellis coding to be used in both
upstream and downstream
directions. If neither the modem
supports trellis coding, the link
will revert to no trellis coding (i.e.,
trellis coding must be used in both
directions if it is to be used).
Enabled, Disabled Enabled
FEC
Redundancy
Bytes
This is the number of forward error
checking coding bytes to be
included in the ADSL superframe.
This value will be used in both the
upstream and downstream
directions, and on both fast and
interleaved paths.
0,2,4,6,8,12,14,16 16
Interleaved
Delay (usec)
The delay on the interleaved path,
in both the upstream and
downstream directions.
0,250,500,1000,
2000,4000, 8000,
16000, 32000,
64000
16000
Table 6-4 Cisco 6100/6130 DSL Physical Port Profile Attributes (continued)
Attribute Description Acceptable Values Default Value