Filter
Top Products
6-6
Cisco Provisioning Center User’s Guide
78-11339-01
Chapter 6 Configuring the Cisco NI-1 DLSAM Equipment Module
Initial System Upload
Creating a Node Object
You should create node objects for all Cisco 6100/6130 nodes in the network. The following steps
explain how to create a node object.
Step 1 From the Root Tree Viewer choose Network > Cisco NI1 DSLAM Network Name > Cisco NI1 DSLAM
Node.
Step 2 Click the Object Viewer button on the toolbar.
Step 3 Enter the attribute values under the Common Attributes and Common Parameters tabs. Refer to
Table 6-3 for attribute information.
Step 4 Save and apply the node object by clicking the Save and Apply buttons.
Table 6-3 lists the attributes for a Cisco 6100/6130 network object. Attributes with an asterisk "*" next
to their Default Value indicates that these fields cannot be changed.
Resource Map This attribute is an integer used to
carry a bit map of services
supported by this network.
0-2147483647 0
Pre-provisioned Not supported in this release. Full, Init, None None*
Table 6-2 Cisco 6100/6130 Network Object Attributes (continued)
Attribute Description Acceptable
Values
Default Value
Table 6-3 Cisco 6100/6130 Node Object Attributes
Attribute Description Acceptable
Values
Default Values
Common Attributes
Name The node name. This attribute is
mandatory.
Text string (up to
64 characters)
Customer The customer name. Text string (up to
16 characters)
Domain The domain name. Text string (up to
16 characters)
Network This is the network that contains
the node. This field is
auto-generated in the Object
Viewer.
Text string (up to
32 characters)
*
Management
Address
The IP address or symbolic name
for the primary system
controller.
Text string (up to
32 characters)