Filter
Top Products
6-21
Cisco Provisioning Center User’s Guide
78-11339-01
Chapter 6 Configuring the Cisco NI-1 DLSAM Equipment Module
Working with Service Element Profiles
ATM Logical Port Profile Attributes
The ATM logical port profile provides you with access to the ATM attributes that you can configure for
an ATM logical port. If you do not create logical port profiles, the Equipment Module will communicate
the values specified in the default logical port profile.
Figure 6-2 shows a Cisco 6100/6130 ATM Logical Port Profile Object Viewer.
Other Attributes
Downstream
PSD Transmit
Power
(dBm/Hz)
Specifies the nominal power output
of an xDSL modem in the
downstream (xTU-C toward
xTU-R) direction, across the entire
transmit spectrum. For certain data
rates this may imply an attenuation
of the transmitted signal. This
value can be specified in
increments of 3 dB/Hz. This
attribute reflects the actual power
output of an xDSL modem that has
been trained.The -34 value is not
applicable to CAP ADSL.
-34, -37, -40, -43,
-46, -49
-40
1. Bandwidth values differ according to the modem card type. For the DMT ADSL modem type, the outgoing
bandwidth follows the pattern (32,64,96, 128... ...786,800,832,864) and the incoming bandwidth follows the
pattern (32,64,96, 128... ...7904, 7968,8000). For the 2BIQSDSL modem type, the outgoing and incoming
bandwidths follows the pattern (144,272,400,528,784,1040,1168). Specified rates that fall between the minimum
and the maximum are always round up to the next valid value.
Table 6-4 Cisco 6100/6130 DSL Physical Port Profile Attributes (continued)
Attribute Description Acceptable Values Default Value