Filter
Top Products
6-20
Cisco Provisioning Center User’s Guide
78-11339-01
Chapter 6 Configuring the Cisco NI-1 DLSAM Equipment Module
Working with Service Element Profiles
Reed Solomon Reed Solomon error encoding can
be configured for the ATU-C
running in CAP mode. Short
interleave, sets the interleave depth
to a smaller value and Long
interleave sets it to a higher value.
Disabling 136K baud will disable
Reed Solomon error correction for
136K baud rates in the downstream
direction. For all other baud rates,
Reed Solomon error correction is
permanently enabled.
Short interleave,
Long interleave,
Disable 136K Baud
Short
Interleave
Allow 17K Baud
(Upstream)
When this attribute is enabled,
ATU-C will include the line rates
corresponding to this baud rate and
also for line rate selection. This
attribute is only valid when the line
encoding type is CAP. If the value
of the line encoding type is
different, changing the value of
this attribute will have no effect.
This baud rate is used only in the
upstream direction.
Enabled, Disabled Disabled
Allow 68K Baud
(Upstream)
When this attribute is enabled,
ATU-C will include the line rates
corresponding to this baud rate and
also for line rate selection. This
attribute is only valid when the line
encoding type is CAP. If the value
of the line encoding type is
different, changing the value of
this attribute will have no effect.
This baud rate is used only in the
upstream direction.
Enabled, Disabled Disabled
Upstream PSD
Transmit Power
(dBm/Hz)
Specifies the nominal power output
of an xDSL modem in the upstream
(xTU-R toward xTU-C) direction,
across the entire transmit
spectrum. For certain data rates
this may imply an attenuation of
the transmitted signal. This value
can be specified in increments of
3 dBm/Hz. This attribute reflects
the actual power output of an xDSL
modem that has been trained.
-38, -41, -44, -47,
-50, -53
-38
Table 6-4 Cisco 6100/6130 DSL Physical Port Profile Attributes (continued)
Attribute Description Acceptable Values Default Value