Filter
Top Products
6-8
Cisco Provisioning Center User’s Guide
78-11339-01
Chapter 6 Configuring the Cisco NI-1 DLSAM Equipment Module
Initial System Upload
Network Upload
Uploading the Fabric and Service Elements for a Network Object
You can upload the fabric and Service elements for a network object by completing the following steps:
Step 1 From the Root Tree Viewer choose Network > Cisco NI1 DSLAM Network Name.
Step 2 Select Upload Both from the Element menu. The upload begins.
When the upload is complete, an upload status window will display. If there were errors during the
upload they would appear in this window.
Version The SNMP version being used
(in the form of
XXXX-XXX-XXR where X is a
numeric digit and R is a R is a
revision letter. This attribute is
usually uploaded.
Text string (up to
32 characters)
*
Cisco 6100/6130 (Systemwide ATU-C CAP settings)
Allow 136kbaud This controls the ability of the
modems to train with a rate that
uses 136K baud. When enabled,
modems are allowed to train
subscribers using 136K baud.
When disabled, modems will not
train using 136K baud. If
subscribers are provisioned for a
rate that requires 136K baud and
the value of this object is
disabled, then the modem will
train the subscriber to the closest
rate that does not use 136K baud.
This attribute only applies if
version 2.4.1 of the DSLAM
software is being used.
Enabled, disabled Disabled
Allow non-timer
CPE trains
Specify whether or not to enable
non-timer CPE trains. This
attribute only applies if version
2.4.1 of the DSLAM software is
being used.
Enabled,
Disabled
Disabled
Table 6-3 Cisco 6100/6130 Node Object Attributes (continued)
Attribute Description Acceptable
Values
Default Values