Filter
Top Products
6-18
Cisco Provisioning Center User’s Guide
78-11339-01
Chapter 6 Configuring the Cisco NI-1 DLSAM Equipment Module
Working with Service Element Profiles
Training Mode The training mode for the physical
port. In standard mode, the modem
attempts to train using the method
specified by T1.413 Issue 2.
FastTrain mode is a proprietary,
optimized training algorithm that
works only if both the near and far
end modems are based on mutually
compatible chipsets. If this is not
the case, training results are
unpredictable. The value of this
attribute will apply to both
upstream and downstream
directions.
Standard, Fast
Train
Standard
G.lite Mode This attribute is only applicable to
4 port FLEX cards. G.lite mode is
enabled on a per board basis so all
ports in the same board should
have the same value for this
attribute. If Enabled is selected, the
modem that the subscriber is
connected to will run in G.lite
mode. The board should be reset
after enabling this attribute.
Enabling this object will reset the
following attributes to their default
values; Interleaved Delay,
Overhead Frame, Incoming
Bandwidth and Outgoing
Bandwidth.
Enabled, Disabled Disabled
Overhead Frame The overhead framing structure
requested for the modem that the
subscriber is connected to. If the
far end modem does not support
this structure, the near end will fall
back to the highest number that the
far end supports. The same framing
structure must be used in both
directions.
ReducedMerged
Fast, Reduced
SeparateFast,
FullAsynch.,Full
Synch
Reduced
MergedFast
Table 6-4 Cisco 6100/6130 DSL Physical Port Profile Attributes (continued)
Attribute Description Acceptable Values Default Value