Filter
Top Products
6-19
Cisco Provisioning Center User’s Guide
78-11339-01
Chapter 6 Configuring the Cisco NI-1 DLSAM Equipment Module
Working with Service Element Profiles
ATU-C CAP
CPE Signature This attribute specifies a CPE
software signature (which
corresponds to a specific version).
If the Allow CPE’s Signature
Detection attribute is Enabled, then
any CPE having a software
signature lower than this value will
not be allowed to train. A value of
zero implies that no rejection will
occur.
0-127 0
Allow CPE’s
Signature
Detection
This attribute controls the
detection and enforcement of
minimum compatible software
levels when the modem port that
the subscriber is connected to
trains to the CPE at the far end. If
this attribute is Enabled, the
modem port retrieves the software
signature during the training
sequence. If disabled, the software
signature provided by the far end
CPE is ignored and the training
sequence is allowed to continue as
normal.
Enabled, Disabled Disabled
Allow 136K
Baud
(Downstream)
Enabling this attribute allows
modems to use the 136K baud rate
when attempting to train at the
requested upstream and
downstream rates
(incoming/outgoing bandwidth). If
this attribute is Disabled, the 136K
baud rate will not be used in the
training algorithm. If the
subscriber is provisioned for rates
that require 136K baud, the modem
will attempt to train at the closest
rate combination not using 136K
baud.
Enabled, Disabled Disabled
Table 6-4 Cisco 6100/6130 DSL Physical Port Profile Attributes (continued)
Attribute Description Acceptable Values Default Value