Filter
Top Products
39-28
Catalyst 3750 Switch Software Configuration Guide
OL-8550-09
Chapter 39 Configuring IPv6 Unicast Routing
Displaying IPv6
Displaying IPv6
For complete syntax and usage information on these commands, see the Cisco IOS command reference
publications.
Table 39-2 shows the privileged EXEC commands for monitoring IPv6 on the switch.
Table 39-3 shows the privileged EXEC command for displaying EIGRP IPv6 information.
Table 39-2 Commands for Monitoring IPv6
Command Purpose
show ipv6 access-list Display a summary of access lists.
show ipv6 cef Display Cisco Express Forwarding for IPv6.
show ipv6 interface interface-id Display IPv6 interface status and configuration.
show ipv6 mtu Display IPv6 MTU per destination cache.
show ipv6 neighbors Display IPv6 neighbor cache entries.
show ipv6 ospf Display IPv6 OSPF information.
show ipv6 prefix-list Display a list of IPv6 prefix lists.
show ipv6 protocols Display IPv6 routing protocols on the switch.
show ipv6 rip Display IPv6 RIP routing protocol status.
show ipv6 route Display the IPv6 route table entries.
show ipv6 routers Display the local IPv6 routers.
show ipv6 static Display IPv6 static routes.
show ipv6 traffic Display IPv6 traffic statistics.
Table 39-3 Commands for Displaying EIGRP IPv6 Information
Command Purpose
show ipv6 eigrp [as-number] interface Displays information about interfaces configured for EIGRP IPv6.
show ipv6 eigrp [as-number] neighbor Displays the neighbors discovered by EIGRP IPv6.
show ipv6 eigrp [as-number] traffic Displays the number of EIGRP IPv6 packets sent and received.
show ipv6 eigrp topology [as-number | ipv6-address]
[active | all-links | detail-links | pending | summary |
zero-successors]
Displays EIGRP entries in the IPv6 topology table.