Filter
Top Products
12-30
Catalyst 3750 Switch Software Configuration Guide
OL-8550-09
Chapter 12 Configuring Interface Characteristics
Configuring the Cisco Redundant Power System 2300
Beginning in user EXEC mode:
Command Purpose
Step 1
power rps switch-number name {string | serialnumber} Specify the name of the RPS 2300.
The keywords have these meanings:
• switch-number—Specify the stack member to
which the RPS 2300 is connected. The range
is 1 to 9, depending on the switch member
numbers in the stack. This keyword is supported
only on Catalyst 3750v2 switches.
• name—Set the name of the RPS 2300, and enter
one of these options:
–
string—Specify the name, such as port1 or
“port 1”. Using quotation marks before and
after the name is optional, but you must use
quotation marks if you want to include
spaces in the port name. The name can have
up to 16 characters.
–
serialnumber—Configure the switch to
use the RPS 2300 serial number as the
name.
Step 2
power rps switch-number port rps-port-id mode {active |
standby}
Specify the mode of the RPS 2300 port.
The keywords have these meanings:
• switch-number—Specify the stack member
connected to the RPS 2300. The range is 1 to 9,
depending on the switch member numbers in the
stack. This keyword is supported only on
Catalyst 3750v2 switches.
• port rps-port-id—Specify the RPS 2300 port.
The range is from 1 to 6.
• mode—Set the mode of the RPS 2300 port:
–
active—The RPS 2300 can provide the
power to a switch when the switch internal
power supply cannot.
–
standby—The RPS 2300 is not providing
power to a switch.
The default mode for RPS ports is active.
Step 3
power rps switch-number priority priority Set the priority of the RPS 2300 port. The range is
from 1 to 6, where 1 is the highest priority and 6 is
the lowest priority.
The default port priority is 6.
Step 4
show env rps Verify your settings.
Step 5
copy running-config startup-config (Optional) Save your entries in the configuration
file.