Filter
Top Products
1-19
Catalyst 3750 Switch Software Configuration Guide
OL-8550-09
Chapter 1 Overview
Default Settings After Initial Switch Configuration
• Port-based traffic
–
Broadcast, multicast, and unicast storm control is disabled. For more information, see
Chapter 25, “Configuring Port-Based Traffic Control.”
–
No protected ports are defined. For more information, see Chapter 25, “Configuring Port-Based
Traffic Control.”
–
Unicast and multicast traffic flooding is not blocked. For more information, see Chapter 25,
“Configuring Port-Based Traffic Control.”
–
No secure ports are configured. For more information, see Chapter 25, “Configuring Port-Based
Traffic Control.”
• CDP is enabled. For more information, see Chapter 26, “Configuring CDP.”
• UDLD is disabled. For more information, see Chapter 28, “Configuring UDLD.”
• SPAN and RSPAN are disabled. For more information, see Chapter 29, “Configuring SPAN and
RSPAN.”
• RMON is disabled. For more information, see Chapter 30, “Configuring RMON.”
• Syslog messages are enabled and appear on the console. For more information, see Chapter 31,
“Configuring System Message Logging.”
• SNMP is enabled (Version 1). For more information, see Chapter 32, “Configuring SNMP.”
• No ACLs are configured. For more information, see Chapter 34, “Configuring Network Security
with ACLs.”
• QoS is disabled. For more information, see Chapter 35, “Configuring QoS.”
• No EtherChannels are configured. For more information, see Chapter 36, “Configuring
EtherChannels and Link-State Tracking.”
• IP unicast routing is disabled. For more information, see Chapter 38, “Configuring IP Unicast
Routing.”
• IPv6 unicast routing is disabled. For more information, see Chapter 39, “Configuring IPv6 Unicast
Routing.”
• No HSRP groups are configured. For more information, see Chapter 42, “Configuring HSRP.”
• IP multicast routing is disabled on all interfaces. For more information, see Chapter 46,
“Configuring IP Multicast Routing.”
• MSDP is disabled. For more information, see Chapter 47, “Configuring MSDP.”
• Fallback bridging is not configured. For more information, see Chapter 48, “Configuring Fallback
Bridging.”