Filter
Top Products
VIP-4R/4T Installation and Configuration 41
VIP Port Adapter Functions
Following is an example of how the show interfaces [type slot/portadapter/port] command displays
status information (including the physical slot and port address) for the interfaces you specify. In
these examples, most of the status information for each interface is omitted, and the four Token Ring
interfaces (0–3) are in chassis slot 3, in port adapter slot 1. (Interfaces are administratively shut down
until you enable them.)
Router# sh int tokenring 3/0/0
TokenRing3/0/0 is administratively down, line protocol is down
Hardware is cyBus TokenRing, address is 0000.0ca5.2300 (bia 0000.0ca5.2389)
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely 255/255, load 1/255
Encapsulation ARPA, loopback not set, keepalive set (10 sec)
Router# sh int tokenring 3/0/1
TokenRing3/0/1 is administratively down, line protocol is down
Hardware is cyBus TokenRing, address is 0000.0ca5.2300 (bia 0000.0ca5.238a)
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely 255/255, load 1/255
Encapsulation ARPA, loopback not set, keepalive set (10 sec)
Router# sh int tokenring 3/0/2
TokenRing3/0/2 is administratively down, line protocol is down
Hardware is cyBus TokenRing, address is 0000.0ca5.2300 (bia 0000.0ca5.238b)
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely 255/255, load 1/255
Encapsulation ARPA, loopback not set, keepalive set (10 sec)
Router# sh int tokenring 3/0/3
TokenRing3/0/3 is administratively down, line protocol is down
Hardware is cyBus TokenRing, address is 0000.0ca5.2300 (bia 0000.0ca5.238b)
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely 255/255, load 1/255
Encapsulation ARPA, loopback not set, keepalive set (10 sec)
Token Ring interface port adapters are always numbered as port adapter 0 because VIPs currently
support only one 4R port adapter with the VIP-4R/4T configuration, and the 4T port adapter is
always in the second port adapter slot location (port adapter slot 1). With this VIP configuration, a
4R port adapter is always in port adapter slot 0.
Refer to Table 3, Table 4, Table 5, Table 6, and Table 7 for the 4R port numbers associated with the
interface processor slots in your chassis.
Note Table 3, Table 4, Table 5, Table 6, and Table 7 indicate 4R interface port numbers based on
the slots in which they can be installed; they do not represent examples of maximum 4R
configurations.
Table 3 4R Slot, Port Adapter, and Port Numbers in a Cisco 7000
Slot 0/
Adapter 0/
Port n
Slot 1/
Adapter 0/
Port n
Slot 2/
Adapter 0/
Port n
Slot 3/
Adapter 0/
Port n
Slot 4/
Adapter 0/
Port n
0/0/0 1/0/0 2/0/0 3/0/0 4/0/0
0/0/1 1/0/1 2/0/1 3/0/1 4/0/1
0/0/2 1/0/2 2/0/2 3/0/2 4/0/2
0/0/3 1/0/3 2/0/3 3/0/3 4/0/3