Filter
Top Products
64 VIP-4R/4T Installation and Configuration
VIP Port Adapter Functions
With the show interfaces type slot/port adapter/port command, use arguments such as the interface
type (serial, and so forth) and the slot, port adapter, and port numbers (slot/port adapter/port) to
display information about a specific serial interface only.
The following example of the show interfaces serial slot/port adapter/port command shows all of
the information specific to the first 4T interface port (interface port 0) in chassis slot 3, port adapter
slot 1:
Router# sh int serial 3/1/0
Serial3/1/0 is administratively down, line protocol is down
Hardware is cyBus Serial, address is 0000.0ca5.2300 (bia 0000.0ca5.2388)
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec, rely 255/255, load 1/255
Encapsulation ARPA, loopback not set, keepalive set (10 sec)
ARP type: ARPA, ARP Timeout 4:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters 2:56:26
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets, 0 restarts
0 output buffer failures, 0 output buffers swapped out
For complete VIP command descriptions and examples, refer to the publications listed in the section
“If You Need More Configuration Information” on page 2.