Filter
Top Products
43
Chapter 2 Printer Operation
Top Menu Sub Menu Default Menu Remarks
After Print Auto Congure
[Auto Cong]
On On
O
Automatically congures optional devices.
On .....AutoCongure enabled (Regardless
of whether Function Select is set, if
a peeler or cutter is installed, each
mode is set automatically.)
O ....AutoCongure disabled (A peeler of
cutter is installed, but to not operate
the peeler or cutter, turn it O and
the operation is selected by Function
Select.)
Function Select
[Function Sel]
Tear O
Tear
Peel On *
Cut On **
Selects the operation when the
AutoCongure is set to O.
Designates the paper position based on
each option. The operation of this device is
enabled during selection.
At the same time, the parameters of the f
command of Prodigy Plus are emulated for
each optional device.
Cutter Action ** Backfeed Backfeed
Through
Cutter operating method setting
Backfeed: it feeds back after each cutting
operation.
Through: when the number copied = n, the
back end of sheet 1 to n-1 passes through,
and the back end of the nal page that is a
single sheet is copied and fed back.
Peel Wait Delay * 0.1 sec 0.1 to 2.0 sec Sets the Peel Wait Delay.
Displays only machines with a peeler
installed.
Paper Position 0.00inch
0.00mm
Peel/Cut/Tear O
0.00 to 2.00 inch
0.0 to 50.8 mm
Peel/Cut/Tear On
-1.00 to 1.00 inch
-25.4 to 25.4 mm
Adjusts the stop position. It is based on the
inch/millimeter setting. There are initial
values of the stop position for each device
set above, and later, relative values are set.
Menu Key Action Enters Menu Repeat Last Set
Repeat Last One
Enters Menu
Sets the menu key action.
Repeat Last Set:
Repeats the number of copies.
Repeat Last One:
Last one is issued only for the nal page.
In the case of a count, afterwards, only
last one is issued.
Enters Menu:
Enters the menu setup mode.
Note: Hold down the MENU key for at least
4 seconds in order to enter the Menu Setup
Mode when setting the “Repeat Last Set” or
“Repeat Last One” menus.
*
Only when peeling option is mounted.
**
Only when cutter is mounted.
Mode Settings
[Datamax® Emulation]