Filter
Top Products
66
Chapter 3 Printer Adjustments
When ribbon loosing occurs in the front ribbon left-right
balance adjustment knob side
Lower the ribbon guide adjustment cam and increase the inclination
of the ribbon guide shaft of the side where there is no loose in the
ribbon (adjustment knob side).
Ribbon guide adjustment cam
4. Once the angle is appropriate, tighten all the screws that
were loosened.
5. Perform print and conrm that there are no wrinkles.
If there are wrinkles, make adjustments again.
NOTE: If the media thickness adjustment dial and media width
adjustment dial are not appropriate, wrinkles may occur in the
ribbon. If wrinkles occur despite adjusting the ribbon guide, adjust
these dials also.
Adjusting the Ribbon
Media Width Adjustment
(p.60)
Media Thickness Adjustment
(p.59)