Filter
Top Products
134
Chapter 5 VMS Operating System
When using the serial interface with the VMS operating system, configure the
terminal characteristics with the SET TERM command, as shown below:
Terminal: _TXA3: Device_Type: Unknown Owner: SYMBIONT_0001
Username: SYSTEM
Input: 9600* LFfill: 0 Width: 132** Parity: None
Output: 9600* CRfill: 0 Page: 66
Terminal Characteristics:
Interactive Echo Type_ahead No_Escape
No_Hostsync TTsync Lowercase Tab
No_Wrap Scope No_Remote No_Eightbit
No_Broadcast No_Readsync Form Fulldup
No_Modem No_Local_echo No_Autobaud No_Hangup
No_Brdcstambx No_DMA No_Altypeahd Set_speed
Line_Editing Overstrike_editing No_Fallback No_Dialup
No_Secure_server No_Disconnect No_Pasthru No_Syspassword
No_SIXEL_Graphics No_Soft_Characters No_Printer_Port Numeric_Keypad
No_ANSI_CRT No_Regis No_Block_mode No_Advanced_video
No_Edit_mode No_DEC_CRT No_DEC_CRT
Device spooled to _DUAL:
* Match baud rate to printer settings.
** When using the Line Printer Plus emulation, the input width is 136.