Filter
Top Products
178
FRAMING ERROR, 144
HAM. COIL OPEN *, 144
HB NOT INSTALLD *, 144
ILL EXT BUS ACC *, 144
ILL INST ACCSS *, 145
ILLGL OPR ACCSS *, 144
INTAKE FAN FAULT, 145
LO DRV. SHORT *, 144, 145
LOAD PAPER, 145
PAP BAD TABLE *, 145
PAP BSY TOO LNG *, 145
PAP FIFO OVERFL *, 145
PAP FIFO UNDRFL *, 145
PAP ILLGL ST *, 145
PAP INCMPL ENER *, 145
PAP INVLD CMD *, 145
PAP INVLD PARM *, 145
PAP NOT SCHED *, 145
PAP NT AT SPEED *, 145
PAP UNEXP INT *, 145
PARITY ERROR, 145
PLAT INV CMD *, 146
PLAT INV PARM *, 146
PLAT INV STATE *, 146
POWER SAVER MODE, 146
POWERSUPPLY HOT *, 146
PRINTER HOT *, 146
PROTECTED INSTR *, 146
PWRSUPP VOLT *, 146
RIB INVLD CMD *, 146
RIB INVLD STAT *, 146
RIBBON DRIVE, 146
RIBBON INK OUT, CHANGE RIBBON, 146
RibbonMinder, 153
SECURITY VIOLATION, 146
SHUTL INV CMD *, 147
SHUTL INV PARM *, 147
SHUTTLE JAM, 147
SOFTWARE ERROR *, 147
STACK OVERFLOW *, 147
STACK UNDERFLOW *, 147
TCB CORRUPTED *, 147
UNDEF INTERRUPT *, 147
UNDFNED OPCODE *, 147
UP DRV. SHORT *, 147
15V PWR FAIL *, 143
23.5V PWR FAIL *, 143
48V PWR FAIL *, 143
8.5V PWR FAIL *, 143
Features list
diagnostic tools
, 14
host interfaces supported, 11
printer emulations supported, 11
text and graphics formatting, 13
FF Valid at TOF, 83
FIRMWARE ERROR message, 144
Font Attributes, 79
Font Set, 101
Format conventions, 9
Forms
slewing
speed
, 113
thick perforations See Open Platen @ BOF
parameter
, 113
Forms Length, 81
Forms Width, 81
Framing error handling, 132
FRAMING ERROR message, 144
G
Graphics
IGP options
, 13
Graphics Options, 96
H
Hammer bank
line matrix printing
, 15
HAM. COIL OPEN * message, 144
Handshaking, IEEE 1284 interface, 127
Hardware installation
unpacking instructions
adjusting paper supports
cabinet model
, 24
pedestal model, 30
attach output basket