Filter
Top Products
Parameters
ipv6–access-
list name
Enter the keywords ipv6–access-list then the access-list
name. The access-list name allows a maximum of 140
characters.
ipv6–prefix-list
name
Enter the keywords ipv6–prefix-list then the prefix-list
name. The prefix-list name allows a maximum of 140
characters.
ipv6–mac-
access-list
name
Enter the keywords ipv6–mac-access-list then the mac-
access-list name. The mac-access-list name allows a
maximum of
140 characters.
Defaults none
Command
Modes
POLICY LIST CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and
Z9000 switches.
Related
Commands
• ipv6 nd ra-guard enable — Allows you to configure the RA guard related
commands.
• ipv6 nd raguard policy policy-name — Defines the RA guard policy name and
enter the RA guard policy configuration mode.
match ra
Enable verifying either of the configured source IPv6 address or prefix address or the source MAC address
in the inspected messages. If this command is not configured, the verification process is bypassed.
Syntax
match ra {ipv6-access-list name | ipv6-prefix-list name | mac-
access-list name}
To reset the access list, use the no match ra{ipv6-access-list | ipv6-
prefix-list | mac-access-list}
command.
Parameters
ipv6–access-
list name
Enter the keywords ipv6–access-list then the access-list
name. The access-list name allows a maximum of 140
characters.
ipv6–prefix-list
name
Enter the keywords ipv6–prefix-list then the prefix-list
name. The prefix-list name allows a maximum of 140
characters.
Neighbor Discovery Protocol (NDP)
1029