Filter
Top Products
std-access-list Specify the standard IP access list that contains the mapping
rules for multicast groups.
source-address Specify the multicast source address to which the groups are
mapped.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
Version 9.7(0.0) Added support for VRF and Introduced on the S6000-ON.
Version 9.5(0.0) Introduced on the Z9500.
Version 9.0.2.0 Introduced on the S6000.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the C-Series and S-Series.
Version 7.7.1.0 Introduced on the E-Series.
Usage
Information
Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reflected
in the IGMP groups. You may not use extended access lists with this command.
When you configure a static SSM map and the router cannot find any matching
access lists, the router continues to accept (*,G) groups.
Related
Commands
ip access-list standard — creates a standard access list to filter based on IP address.
ip igmp version
Manually set the version of the router to IGMPv2 or IGMPv3.
S6000
Syntax
ip igmp version {2 | 3}
Parameters
2 Enter the number 2 to set the IGMP version number to
IGMPv2.
3 Enter the number 3 to set the IGMP version number to
IGMPv3.
Defaults 2 (that is, IGMPv2)
646
Internet Group Management Protocol (IGMP)