Filter
Top Products
Version
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage
Information
The dot1p-priority command changes the priority of incoming traffic on the
interface. The system places traffic marked with a priority in the correct queue and
processes that traffic according to its queue.
When you set the priority for a port channel, the physical interfaces assigned to the
port channel are configured with the same value. You cannot assign the dot1p-
priority command to individual interfaces in a port channel.
rate police
Police the incoming traffic rate on the selected interface.
S6000
Syntax
rate police [kbps] committed-rate [burst-KB] [peak [kbps] peak-
rate [burst-KB]] [vlan vlan-id]
Parameters
kbps Enter the keyword kbps to specify the rate limit in Kilobits
per second (Kbps). The range is from 0 to 40000000. The
default granularity is Megabits per second (Mbps).
committed-
rate
Enter the bandwidth in Mbps. The range is from 0 to 40000.
burst-KB (OPTIONAL) Enter the burst size in KB. The range is from 16
to 200000. The default is 50.
peak peak-rate (OPTIONAL) Enter the keyword peak then a number to
specify the peak rate in Mbps. The range is from 0 to 40000.
vlan vlan-id (OPTIONAL) Enter the keyword vlan then a VLAN ID to
police traffic to those specific VLANs. The range is from 1 to
4094.
Defaults Granularity for commited-rate and peak-rate is Mbps unless you use the kbps
option.
1250
Quality of Service (QoS)