Filter
Top Products
Route-map configuration on a BGP peer or peer group works only when the LOC-
RIB contains at least one route.
When you apply a default route to a BGP peer or peer group using the neighbor
default-originate command, changes to the configured default route-map
are applied to the BGP peer or peer group only after a delay of 15 seconds. As a
result, you must wait for a period of 15 seconds before manually resetting BGP
using the
clear ip bgp command.
In case of eBGP, the neighbor default-originate command does not
support
extended-community as a non-transtive route-map attribute.
You cannot set this configuration for a peer that is associated with a peer group.
Similarly, you cannot associate a peer to a peer group if that peer is already
configured with these settings.
In order that settings corresponding to the neighbor default-originate
command take effect, you must execute the clear ip bgp command
immediately after you execute the neighbor default-originate command.
neighbor description
Assign a character string describing the neighbor or group of neighbors (peer group).
S6000
Syntax
neighbor {ip-address | peer-group-name} description text
To delete a description, use the no neighbor {ip-address | peer-group-
name} description command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name
Enter the name of the peer group.
text Enter a continuous text string up to 80 characters.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
Border Gateway Protocol
385