Filter
Top Products
NOTE: When you set this option, the router accepts BGP
prefixes only until the maximum configured value. After
the maximum number is reached, the router drops any
additional prefixes that it receives.
Defaults threshold = 75
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
If you configure the neighbor maximum-prefix command and the neighbor
receives more prefixes than the neighbor maximum-prefix command
configuration allows, the neighbor goes down and the
show ip bgp summary
command displays (prfxd) in the State/PfxRcd column for that neighbor. The
neighbor remains down until you enter the clear ip bgp command for the
neighbor or the peer group to which the neighbor belongs or you enter the
neighbor shutdown and neighbor no shutdown commands.
Related
Commands
show ip bgp summary — displays the current BGP configuration.
neighbor password
Enable message digest 5 (MD5) authentication on the TCP connection between two neighbors.
S6000
Syntax
neighbor {ip-address | peer-group-name} password [encryption-
type] password
To delete a password, use the no neighbor {ip-address | peer-group-
name
} password command.
Border Gateway Protocol
391