Filter
Top Products
Example
Dell#configure terminal
Dell(conf)#ip vrf red
Dell(conf-vrf)#description "Red Network"
Dell(conf-vrf)#show config
!
ip vrf red 4
description "Red Network"
Dell(conf-vrf)#
Dell(conf-if-te-1/45)#int te 7/46
Dell(conf-if-te-1/46)#no shut
Dell(conf-if-te-1/46)#ip vrf forwarding red
Dell(conf-if-te-1/46)#ip add 100.1.1.1/24
Dell(conf-if-te-1/46)#
Dell(conf-if-te-1/46)#
Dell(conf-if-te-1/46)#
Dell(conf-if-te-1/46)#show config
!
interface TenGigabitEthernet 1/46
ip vrf forwarding red
ip address 100.1.1.1/24
no shutdown
Dell(conf-if-te-1/46)#
ip route-export
Enables route leaking between VRFs. Exports or shares IPv4 routes corresponding to one VRF with other
non-default VRFs.
Syntax
ip route-export tag [route-map-name]
Parameters
route-export Enter the keyword to leak or share routes between VRFs.
tag Enter a tag (export route target) to expose routes to other
VRFs. This tag acts as an identifier for exported routes. You
can use this identifier while importing these routes into
another non-default VRF.
route-map-
name
(Optional) Enter the name of the route-map to filter the
exported routes.
You can leak global routes to be made available to VRFs. As
the global RTM usually contains a large pool of routes, when
the destination VRF imports global routes, these routes will
be duplicated into the VRF's RTM. As a result, it is mandatory
to use route-maps to filter out leaked routes while sharing
global routes with VRFs.
Defaults N/A
Command
Modes
VRF MODE
CONFIGURATION
1610
Virtual Routing and Forwarding (VRF)