Filter
Top Products
peer-group-
name
Enter the name of the peer group to disable or enable all
routers within the peer group.
Defaults Disabled
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.4.1.0 Introduced.
Usage
Information
This command enables soft-reconfiguration for the BGP neighbor specified. BGP
stores all the updates the neighbor receives but does not reset the peer-session.
You cannot set this configuration for a peer that is associated with a peer group.
Similarly, you cannot associate a peer to a peer group if that peer is already
configured with these settings.
CAUTION: Inbound update storage is a memory-intensive operation. The
entire BGP update database from the neighbor is stored in memory
regardless of the inbound policy results applied on the neighbor.
NOTE: This command is supported in BGP Router Configuration mode for
IPv4 Unicast address only.
Related
Commands
show ip bgp neighbors — displays routes received by a neighbor.
neighbor timers
Set keepalive and hold time timers for a BGP neighbor or a peer group.
S6000
Syntax
neighbor {ip-address | peer-group-name} timers keepalive
holdtime
Border Gateway Protocol
403