Filter
Top Products
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810. Added support for source-
interface for link-local IPv6 addressing.
8.3.11.1 Introduced on the Z9000.
8.2.1.0 Introduced on the E-Series ExaScale (IPv6). Increased the
number of VLANs on ExaScale to 4094 (was 2094).
8.1.1.0 Introduced on the E-Series ExaScale (IPv4).
7.9.1.0 Introduced VRF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series and added support for IPv6
address on the E-Series only.
Usage
Information
The VRF configured using this command has a higher precedence than a VRF
configured using the ip telent vrf vrf-name command. If you do not use the
VRF attribute in this command, then TELENT client uses the VRF configured using
the ip telnet vrf vrf-name command.
The source interface configured using this command has a higher precedence than
the source interface configured using the ip telent source-interface
command. If you do not configure a source interface using this command, then
the TELNET client uses the source interface configured using the ip telent
source-interface
command.
In case there is a mismatch between the VRF telnet source interface and the telent
VRF, then an error is reported.
Example
Dell#telnet vrf vrf1 10.10.10.2
telnet-peer-stack-unit
Open a Telnet connection to the peer stack unit.
Syntax
telnet-peer-stack-unit
Defaults Not configured.
Command
Modes
• EXEC
Control and Monitoring
153