Filter
Top Products
• If overlapping port ranges are specified, the port range is extended to the
smallest start port and the biggest end port.
Example (Bulk)
Dell(conf)#interface range tengigbitethernet 2/1 - 11,
fortyGigbE 3/3, tengigbitethernet 3/10
% Warning: Non-existing ports (not configured) are ignored by
interface-range
Example
(Multiple Ports)
Dell(conf)#interface range tengigabitethernet 2/10 - 23,
tengigabitethernet 2/12 - 17
Dell(conf-if-range-te-2/10-23)#
Example
(Overlapping
Ports)
Dell(conf)#interface range tengigabitethernet 2/3 - 11,
tengigabitethernet 2/3 - 23
Dell(conf-if-range-te-2/3-23)#
Usage
Information
Only VLAN and port-channel interfaces created using the interface vlan and
interface port-channel commands can be used in the interface range
command.
Use the show running-config command to display the VLAN and port-channel
interfaces. VLAN or port-channel interfaces that are not displayed in the show
running-config command cannot be used with the bulk configuration feature of
the interface range command. You cannot create virtual interfaces (VLAN,
Port-channel) using the
interface range command.
NOTE: If a range has VLAN, physical and port-channel interfaces, only
commands related to physical interfaces can be bulk configured. To configure
commands specific to VLAN and port-channel only those respective interfaces
should be configured in a particular range.
Example (Single
Range)
This example shows a single range bulk configuration.
Dell(config)# interface range tengigabitethernet 5/3 - 23
Dell(config-if-range-te-5/3-23)# no shutdown
Dell(config-if-range-te-5/3-23#
Example
(Multiple
Range)
This example shows how to use commas to add different interface types to the
range enabling all Tengigabit Ethernet interfaces in the range 5/1 to 5/23 and both
Tengigabit Ethernet interfaces 1/1 and 1/2.
Dell(config-if)# interface range tengigabitethernet 5/1 -
5/23, tengigabitethernet 1/1 - 1/2
Dell(config-if-range-te-1/1-2,te-5/1-23)# no shutdown
Dell(config-if-range-te-1/1-2,te-5/1-23)#
Example
(Multiple
Range)
This example shows how to use commas to add VLAN and port-channel interfaces
to the range.
Dell(config-if)# interface range tengigabitethernet 5/1 - 23,
tengigabitethernet 1/1 – 2,
Vlan 2–100, Port 1–25
Dell(config-if-range-te-1/1-2,te-5/1-23,vl-2-100,po-1-25)# no
682
Interfaces