Filter
Top Products
Installing System Components | 105
Installing the 10GbE Mezzanine Card
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
1 Put the two ports of the 10GbE mezzanine card through the two slots
of the bracket. See Figure 3-16.
2 Install the three screws to secure the 10GbE mezzanine card to the
bracket. See Figure 3-16.
3 Install the 10GbE mezzanine-card assembly to the mezzanine-card
bridge board on the system-board assembly. See Figure 3-15.
4 Install the three screws to secure the 10GbE mezzanine-card assembly
to the system-board assembly. See Figure 3-15.
5 Reconnect all the cables to the 10GbE mezzanine card.
6 Replace the system-board assembly. See "Installing a System-Board
Assembly" on page 88.
7 Reconnect the system to its electrical outlet and turn on the system,
including any attached peripherals.