Filter
Top Products
Using the System Setup Program | 69
Token Setup Option Description
009C Legacy USB Support Disable USB emulation
00A1 Restore on AC power Loss
After an AC power loss, when AC power
is restored, the system will stay off.
00A2 Restore on AC power Loss
After an AC power loss, when AC power
is restored, the system will return to the
state was in when power was lost.
00A3 Restore on AC power Loss
After an AC power loss, when AC power
is restored, the system will power on.
00BB NIC2 Option ROM
Enable the system’s secondary
embedded network interface controller,
but does not enable the NIC’s associated
PXE or RPL boot-ROM.
00BC NIC2 Option ROM
Enable the system’s secondary
embedded network interface controller
(full-function), including its PXE boot-
ROM.
00BF Remote Access Serial Console Redirection Off.
00C0 Remote Access
Serial Console Redirection On, output
to COM1. See also token D7h.
00CA CS Sparing Enabled Disable Redundant memory.
00CB CS Sparing Enabled Enable Redundant memory.
00D7 Serial port number Console redirection to COM2.
00D8 Load Optimal Default Load Optimal Default.
0135 OnChip SATA Channel Disable Onboard SATA controller(s).
0137 OnChip SATA type
Onboard SATA controller(s) is set to
Native IDE mode.
0138 OnChip SATA type
Onboard SATA controller(s) is set to
AHCI mode.
013B OnChip SATA Channel Enable Onboard SATA controller(s).
0173 Hardware Prefetcher Disable CPU HW Prefetcher.
0174 Hardware Prefetcher Enable CPU HW Prefetcher.
01C4 ACPI SRAT Table Disable for ACPI SRAT Table.
01C5 ACPI SRAT Table Enable for ACPI SRAT Table.
021F Power Management This will set max. performance.
0221 Power Management Allow OS to control p-state.